2" x 8' 3M 5510 Heat Transfer Reflective Slash-Hash - Silver


New breathable and lightweight this 3M quality product is perfect for heat transfer (iron on) applications.

Description 3M Scotchlite Reflective Material Series 5500 Comfort Trim is comprised of industrial and home wash products.
3M Scotchlite Reflective Material 5510 Segmented Home Wash Trim is a transfer film composed of wide angle, exposed retroreflective lenses bonded with a special polymer layer to a heat activated polyester adhesive.
The trim is 2 inches wide and comprised of reflective patterned segments on a plastic liner.

Note: width modification other than 2-inch will affect physical performance. Scotchlite reflective material 5510 segmented home wash trim should not be used for flame resistant applications.

Home Wash Home laundering means using a top or front loading consumer type home washing machine with a consumer detergent at moderate water temperatures (up to 60 C).
Garment finishing (tumble dry or tunnel finish) can limit garment life and should be considered as part of the cleaning process.

Application Instructions Whenever two or more pieces of Scotchlite reflective material 5510 segmented home wash trim are used together on a single surface or as a set, they should be matched to ensure uniform daytime color and nighttime reflectivity.

Cutting: Scotchlite reflective material 5510 segmented home wash trim can be hand-cut, die-cut or guillotined.
Plotter cutting is not recommended.
NOTE: Width modification other than 2-inch will affect physical performance.

Heat Lamination: The following recommendation is a general guideline for heat press lamination
. Other lamination methods such as roll to roll, heat fusing, and High Frequency (HF) welding can also be used.

Important note: The proper temperature/ pressure/time conditions must be tested for each fabric to assure adequate adhesion and physical performance. Many fabrics can be used as lamination substrates, however, nylons and fabrics treated with a durable water repellent (DWR) finish are difficult to adhere to and are not recommended.
For specific application assistance, contact 3M Technical Service.

Work on a flat surface where uniform heat and pressure can be applied. Avoid applying film over seams and stitches.
Place film on fabric (substrate) adhesive side down and apply heat and pressure as described below.
Allow the application to cool to room temperature before removing the plastic liner.
Place application on a flat surface and remove the plastic liner by lifting one corner and pulling at about a 45 angle in a continuous, smooth manner.

Add to Cart:

  • Model: 41314
  • Shipping Weight: 0.1kgs
  • 6 Units in Stock

This product was added to our catalog on Monday 29 August, 2011.

Your IP Address is:
Copyright © 2020 Hoop Tape Canada, a division of HollyNorth Production Supplies Ltd. Powered by Zen Cart
Hoop Tape Logo